With the increasing complexity of electronic products , electromagnetic compatibility issues become increasingly prominent , the state of the electromagnetic compatibility requirements of electronic products is also increasing. Whether military and civilian , should follow the national or industry standards for electromagnetic compatibility standard test , which has become a standard inspection of product quality. In order to meet customer requirements and national standards , the company offers a full suite of EMC standard test equipment , in full compliance with the military (GJB151 / 152A, MIL-STD-461) and civil (EN / IEC, FCC, CISPR) Electromagnetic Compatibility Test requirements .

STANDARD TEST EQUIPMENT

    • Emissions Reference Source (ERS)

      The ERS is a comb generator that radiates RF continuously every 2MHz over the range 30MHz - 1000MHz. Each 2MHz peak is precisely measured during the calibration process with the ERS orientated both vertically and horizontally. These measurements are correlated against a 3m OATS such that any fully implemented CISPR16 site.

      넶1 ¥ 0.00

    • LN-16 Line Impedance Stabilization network

      LISN, namely the line impedance stabilization network , also known as artificial
      mains network (AMN). When the test series with the DUT power feed line. It is
      within a given frequency range , offers standard 50 -ohm load impedance
      disturbance voltage measurement , and test equipment and power supply isolated
      from each other.

      넶1 ¥ 0.00

    • Electrostatic discharge generator -SESD 216

      Electrostatic generator SESD 216 can simulate the static IEC / EN 61000-4-2
      standard defines the discharge , relying on the device under test (EUT) and
      test set- laboratory testing.

      넶3 ¥ 0.00

    • RF Power Amplifiers

      LAPLACE amplifier is cooled RF broadband amplifier, using a wide range,
      good linearity while greater bandwidth and gain , the last stage in a typical
      solid-state push-pull amplification , and therefore has excellent performance
      and better stability intermodulation characteristics. Meet all the performance
      and characteristics of EMC / EMI standard test (IEC61000-4-3 RF immunity
      standard ) requirements.

      넶2 ¥ 0.00

    • Monopole antenna

      Monopole antenna Monopole antenna provides a high-performance field testing
      tools , active monopole antenna can drive any receiver has impedance of 50W
      and can be FCC, MIL-STD and TEMPEST standard tests , while passive monopole
      antenna can be used transmitting, implementation of shielding effectiveness and
      immunity testing.

      넶1 ¥ 0.00

    • Dipole antenna

      Each comprising one to four baluns, but each balun can be sold separately.

      넶2 ¥ 0.00

    • Loop antenna

      Loop antenna AH Systems designs, manufactures and
      markets high-performance loop antennas that can be used in a very wide range
      field tests , either as shielding effectiveness of a test device ( in accordance
      with MIL-STD 285 and NSA 65-6 standards) or independent testing for safety
      indicators , these loop antenna is an effective, low- cost solutions.


      넶1 ¥ 0.00
넳 넲